vacuum adapter (CARP)

Price:

€ 73.55


edelkastanje/tamme kastanje (30 mm dik)
edelkastanje/tamme kastanje (30 mm dik)
€ 1.45
€ 1.45

vacuum adapter (CARP)

https://www.dehoutdraaierij.nl/web/image/product.template/1920/image_1920?unique=5b8aa32
(0 review)

€ 73.55 73.55 EUR € 73.55 € VAT Included

Not Available For Sale


This combination does not exist.

CARP Vacuum Adapter – Vacuum Chucking for Woodturning Lathes

Vacuum chucking allows you to hold workpieces on your woodturning lathe without using a scroll chuck or a revolving centre. It is particularly useful when finishing the underside of bowls and platters. You can work on the entire outside of the piece without a chuck or other holding device getting in the way.

How does vacuum chucking work?

With vacuum chucking, air is extracted from between the workpiece and a special vacuum chuck, creating a vacuum. Atmospheric pressure then presses the workpiece firmly against the vacuum chuck.

The larger the surface area exposed to the vacuum, the greater the holding force. A good airtight seal is essential.

CARP Vacuum Adapter

The CARP vacuum adapter is inserted into the hollow headstock spindle from the left-hand side of the lathe. A rubber sealing ring on the adapter ensures an airtight connection.

The adapter features an integrated bearing, allowing the spindle to rotate freely while the vacuum hose connection remains stationary. This means the hose does not rotate with the spindle.

The adapter is suitable for virtually all woodturning lathes with a 5/8-inch (15.875 mm) spindle bore, such as the CARP 2432 MEGA.

The adapter can be used with an external vacuum pump or a Venturi system, such as the one built into the CARP 2432 MEGA. This system uses compressed air to generate a vacuum, eliminating the need for a separate vacuum pump.

The adapter comes with 50 cm (19") of pressure hose with a diameter of 10 mm.

What should you keep in mind?

  • Only use vacuum chucking with dry, sufficiently dense wood.
  • Cracked or porous wood may allow air to leak through, resulting in insufficient holding force.
  • Always check that the workpiece is securely held before switching on the lathe.
  • Take light cuts and adjust the spindle speed to suit the workpiece and the holding method.
  • Do not turn the bottom of bowls too thin. A high vacuum can cause a thin bottom to be pulled inwards or even collapse. And believe me, that makes one HELL of a BANG! :-)


Share :
Similar Products
Accessory Products